Category：Environmental friendly stabilizers for rigid PVC
|Recommended Dosage||3～4 phr|
|Application Scope||Extrusion of PVC profiles and profiles of different shapes|
|Technical Index||Appearance||White or yellowish powder or granules|
|Loss on Heating (%)||≤3.0|
|Initial Melting Point (℃)||≥50|
A) Excellent heat stability and weather ability. Good dynamic lubrication balance.
B) Compliance with GB/T33284-2016 standard. Safe and environmental friendly.
C) Anti-sulfide pollution. Can replace organotin stabilizers. No need to clean the machine.
D) Fast extrusion, high outturn rate.
E) Can be used for powder direct moulding.F) Can be produced for long time. Long cycle time of mould cleaning.
|Security||Compliance with EU RoHS & REACH and other standards.|
|Transport and Storage||Keep away from sunlight and moisture.|
|Notice||The technical information of this specification was obtained through tests and actual using process. However, the specific dosage when using should be in accordance with the formula, equipment and process, etc.|